cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Creo mirror part

cjohansson-2
1-Newbie

Creo mirror part

When I use mirror in part mode I usually prefer to mirror the complete part.

Is there any way to exclude planes from being mirrored.

I usually have no use of the mirrored planes and I prefer to add mates in assembly to original planes like side or top plane.

Wrong planes can easily be selected by mistake.



This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 ACCEPTED SOLUTION

Accepted Solutions

No. Mirror the complete part and you mirror everything in it, including planes. You can "hide" the mirror feature afterwards, which makes a lot of the stuff invisible.

View solution in original post

2 REPLIES 2

No. Mirror the complete part and you mirror everything in it, including planes. You can "hide" the mirror feature afterwards, which makes a lot of the stuff invisible.

View solution in original post

You can mirror the geometry in a couple steps. Once you have one side designed select a surface and then right click to select all solid surfaces. Then Copy and paste. Then mirror this new copied surface to the other side. Then solidify the new mirrored surface quilt.

Announcements