The problem:
I create similar assemblies very often, and make section views. Going through every time to retrieve the material for each part's hatching takes quite a long time. Then I have to edit the spacing, the angle, and so on.
What I'm looking for:
A way that I can set the material, crosshatch pattern, spacing, and angle in the part mode. That way, once the assembly is brought into the drawing, all parts have their specific cross hatch pattern, and I won't have to set the cross hatch options. (Maybe just a little tweaking if patterns look too close)
Is there a way to do this? Or am I hoping for too much from Proe?
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
