Cross section in 2D in isometric view

[mn.nielsen]

Hi Pro users,

I was wondering if it's possible to make ax-section in an isometric view in a 2D drawing?

Thanks in advance

Mic

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[dbowles]

Yes, create an offset Xsection in the model. It can be a straight line if
needed. this will allow a it to be shown in an iso view.

Douglas K. Bowles
Advanced Systems Harn/Des
520-746-2019 Office
520-490-9395 Cell
-

[mn.nielsen]

Thanks for your answers, here andby mymail.I will tryan see ifI canmake it work.

Best regards

Michael