Datum point name in custom symbol attached to it.
May 05, 2015
10:19 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
May 05, 2015
10:19 AM
Datum point name in custom symbol attached to it.
Hello,
Is it possible to create a custom symbol that shows the datum point name of which it is attached?
It will replace the standard datum target symbol.
The reason is that I have a table with measurement points (exported hole table, using the datum point) on the drawing and I want the locations identified by datum target balloons.
See also picture.
Thanks for the help.
Johnny
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
- Labels:
-
General
0 REPLIES 0
