Default model/scale for a drw sheet
‎Sep 04, 2010
04:53 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Sep 04, 2010
04:53 PM
Default model/scale for a drw sheet
When you create a new sheet in a multi-sheet drawing the sheet gets a
default model and scale.I can't figure out how to find out what the default
model is. You can't look for answers in the Format parameters because if
you replace the Format, then the Format parameters get tied to the currently
active model which can be different from the "sheet" default model. The
reason for this question is, in a drawing of a weldment (assy) with several
part models added, the Default Scale for Sheet option that shows in the View
property dialog box will display this "sheet default scale" which can be
(and in this case is) different from both Titleblock scale and the scale in
the drawing mode status area at the bottom of the screen.
Using WF4.
Thanks in advance,
Gavin B. Rumble, PE
Solid Engineering
336-224-2312
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
default model and scale.I can't figure out how to find out what the default
model is. You can't look for answers in the Format parameters because if
you replace the Format, then the Format parameters get tied to the currently
active model which can be different from the "sheet" default model. The
reason for this question is, in a drawing of a weldment (assy) with several
part models added, the Default Scale for Sheet option that shows in the View
property dialog box will display this "sheet default scale" which can be
(and in this case is) different from both Titleblock scale and the scale in
the drawing mode status area at the bottom of the screen.
Using WF4.
Thanks in advance,
Gavin B. Rumble, PE
Solid Engineering
336-224-2312
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
- Labels:
-
General
0 REPLIES 0