cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Develop a GUI for Gear Spline Tooth Using Existing Spline Data from a Drawing or Machinist Handbook

ptc-728881
3-Visitor

Develop a GUI for Gear Spline Tooth Using Existing Spline Data from a Drawing or Machinist Handbook

Develop a GUI for the development of gear tooth sketch using existing spline data from a drawing or machinist handbook.


Attached is an example of spline data from a drawing.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 REPLY 1

Ken,

You may want to put this as a product idea instead of a discussion if that is what you are asking.

Thanks, Dale

Announcements