cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Dimension from pattern feature is not shown in correct place between 3D annotation and drawing

汐xie
5-Regular Member

Dimension from pattern feature is not shown in correct place between 3D annotation and drawing

Hi ,

 

The dimension from pattern feature is not shown in correct place between 3D annotation and drawing.

The dimension is created in the first instance of pattern and shown correctly in 3D annotation. But it is shown in another instance of pattern in 2D drawing, not the same place as created.

Please check the picture and model & drawing for detailed information.

1 ACCEPTED SOLUTION

Accepted Solutions
MartinHanak
23-Emerald V
(To:汐xie)

Hi,

the result deppends on the method you used to display annotation.

See uploaded video.


Martin Hanák

View solution in original post

3 REPLIES 3
MartinHanak
23-Emerald V
(To:汐xie)

Hi,

the result deppends on the method you used to display annotation.

See uploaded video.


Martin Hanák
汐xie
5-Regular Member
(To:MartinHanak)

Thanks a lot Martin for your feedback. 

Great to see you can show that annotation correctly by showing in drawing view.

 

Regarding the zipped file, I firstly uploaded them all with dragging and dropping, but only the part file failed as it was not recognized by system.  so I zipped it alone not sure if the zip file was supported. I will put them all in zip file next time.

Thanks again for your investigation on this issue. Have a nice day.

MartinHanak
23-Emerald V
(To:汐xie)

Hi,

please next time pack all Creo files into single zip file.


Martin Hanák
Announcements