Drawing Parameter :d broken

[dhebel]

I used to enter &model_name:d into the title block.  We just upgraded to CREO 10.  I tried adding the parameter to the drawing even.

[KenFarley]

Does &model_name without the ":d" work?

[MartinHanak]

Hi,

according to https://support.ptc.com/help/creo/creo_pma/r10.0/usascii/index.html#page/detail/System_Parameters_for_Drawings.html document model_name is drawing system parameter. This means that the 😄 suffix does not need to be specified.

[MartinHanak]

[StephenW]

To get the filename of the current active part or assembly in a drawing, use &model_name

To get the filename of the drawing in the drawing, use &dwg_name

The (:d) option is valid for drawing parameters, not system parameters

[anursingh]

Hi @dhebel,

I wanted to see if you got the help you needed.

If so, please mark the appropriate reply as the Accepted Solution. It will help other members who may have the same question.
Please note that industry experts also review the replies and may eventually accept one of them as solution on your behalf.
Of course, if you have more to share on your issue, please pursue the conversation. 

Thanks,
Anurag