Drawing view scale
‎Jul 31, 2013
06:31 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Jul 31, 2013
06:31 AM
Drawing view scale
In some cases when we are using cutaways (local sections) in drawing views, we require to add a new note for the view showing the scale. However the view scale in that note will not be parametric. Is there any way to associate the drawing view scale parameter inside a non parametric note ?? (&view_scale) is not taking when it was put it inside the note.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Solved! Go to Solution.
Labels:
- Labels:
-
2D Drawing
ACCEPTED SOLUTION
Accepted Solutions
‎Apr 21, 2015
05:46 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Apr 21, 2015
05:46 PM
Old thread, but I just noticed this in the help documentation:
1 REPLY 1
‎Apr 21, 2015
05:46 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Apr 21, 2015
05:46 PM
Old thread, but I just noticed this in the help documentation: