Family Table Drawings

[BobWinslow]

Is there a way to replace a family table member, in an existing view, in an established drawing?

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[mender]

You can replace a top drawing model globally in the drawing, with Drawing Models > Replace, to take a drawing of BOLT_8_10<BOLT_GENERIC> and produce a drawing of BOLT_8_12<BOLT_GENERIC>.  Replacing in an individual view but not other views, you can't do in the current shipped software (but see posts by Raphael Nascimento on Creo 4 work in this area.)

[BobWinslow]

Thanks Matthew.

It is the entire drawing that I want to affect. I was evidentally "setting" the new/added model, and not doing the full "replace.