windows xp 64bit
pro/e 3.0
i attached a picture of a 2 part assembly x-section. I want to fill in the gap seen in the attached figure (within the red arrows) with orange material. Is there a pro/e operation opposite to 'cut out' that can fill in this gap?
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
