cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Flip Datum to bottom of GTOL reference frame

akelly
11-Garnet

Flip Datum to bottom of GTOL reference frame

Using Creo 2 M090.

I've got a drawing with a GTOL reference frame as a free note. I have a datum flag that's anchored to it using "on GTOL", but showed up attached to the top of the GTOL reference frame. I can't figure out how to flip the flag to the bottom of the GTOL reference frame.

-- Andrew

Andrew Kelly, P.E.
Design Engineer
Honeywell Sensing and Control
2080 Arlingate Lane
Columbus, OH 43228
Office: 614-850-7818
Toll Free: 800-848-6564
Fax: 614-850-1111
andrew.kelly@honeywell.com<">mailto:andrew.kelly@honeywell.com>




This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
0 REPLIES 0
Announcements