Greater Than Or Equal To Sign

[mjenkins]

Can anybody help me out on the procedure to insert a greater than or equal sign into a ProE drawing?

I found the Alt code is Alt-242 and it shows in the properties box but when I close the note, it just shows as a box in the drawing.

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[mjenkins]

Got some good replies. What I had to do was copy all the ttf files from:

"C:\Windows\Fonts"

To >

"C:\Program Files\proeWildfire 4.0\text\fonts"

Then I picked Arial and it showed up just finewhen I used Alt 242.

[A.DelNegro]

I need a little help with a draft. On this part (this is a sample, not
my actual part), how can I get the draft to split along the center-line
of the part? We will put in 3 directions with this mold, 2 normal to
the orange plane shown and 1 up away from the cylinder end. I would
like the 2 semicircles to look the same. At this point, I can only get
them to split at one point that is off-center. Since the cylinder was
made first, the circular surface acts as one, and not 2 surfaces.



Tony