Help in Creo 2.0
Jan 21, 2014
11:05 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Jan 21, 2014
11:05 PM
Help in Creo 2.0
I need some help with CREO 2.0. I loaded it in and started to follow the directions to load the bike into Creo. I can not seem to make the bike appear. Any sugestions
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
- Labels:
-
General
2 REPLIES 2
Jan 22, 2014
11:46 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Jan 22, 2014
12:19 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Jan 22, 2014
12:19 PM
Updating your graphics driver should fix this for you. If that doesn’t help, please try the suggested config.pro options in this document: http://apps.ptc.com/schools/references/support_creo2_graphics.pdf
Regards,
Adam
Academic Technical Support:
- For all academic support of PTC Creo and secondary school support (K12) of PTC Mathcad, please see the PTC Academic Support forum. If you are unable to find a solution to your issue in the forum, submit an Academic Support Request.
- For University and e-store support of PTC Mathcad, please use the Mathcad Support Wizard.