Hello, I have used a sweep-surface trim to trim a quilt that was previously closed - now I have the geometry I want but there is a hole in the model where the cut went thru. Is there a way to retain this surface as the cut goes thru? What feature will close this hole I have? I need it close so I can solidify it later. Thanks, Matt
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
