Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X
Hi,
When we are going to place repeat region bom balloons, it is getting overlapp so we need to move it manually.
So is there any option or method to avoid this.
FYI. snap is given as below.
Thanks,
Prashant Pandarkar
I tend to place balloons by component so that only a few are dealt with at one time.
This is too common issue of Pro/E and Creo Parametric. I also recommend creating the balloons by component. Don't even bother with the Cleanup BOM Balloons functionality.