cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

How to creat text symbol feature?

zhenqiang
8-Gravel

How to creat text symbol feature?

Hello,

I design equipments control panel,there may be much symbols silkscreen or engraved on the panel's surface(the panel may metal or poly materials),So I just creat a sketch feature on the surface,but it looks not reality.What I can thought out methods is to extrude the sketch but complicated.Any other better practices to represent texts?


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 REPLY 1
Dale_Rosema
23-Emerald III
(To:zhenqiang)

Check out the following discussions:

http://communities.ptc.com/message/227997#227997

http://communities.ptc.com/message/246468#246468

http://communities.ptc.com/message/244175#244175

It looks like some of them were for control panels too.

Thanks,

Dale

(my search criterion was "Antonius text")

Thanks Antonius for all you do

Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags