cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Stay updated on what is happening on the PTC Community by subscribing to PTC Community Announcements. X

How to create the intersection on drawing in pro WF 5.0

bvsrao
1-Newbie

How to create the intersection on drawing in pro WF 5.0

How to create the intersection on drawing in pro WF 5.0


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
2 REPLIES 2
VladimirPalffy
13-Aquamarine
(To:bvsrao)

Hi

I make for you short video. You can Show model dimensions or Create drived dimensions in drawing, then you can create intersection lines - see here:

Video Link : 1905

Vladimir

Best Regards,
Vladimir Palffy

Another technique you might want to be aware of is the following. If you create that rounded corner inside Sketcher, you can place a Sketcher Point at the intersection of the two lines before adding the Fillet, then dimension to that point. If you do it that way you actually have a dimension that can be Shown as opposed to Created as illustrated in Vladimir's video.

Top Tags