I am very sorry for asking such basic questions.
I have successfully added some 3 Dimensions, which I intend to use to modify a part. (I have figgured out that you can't dimension the initial sketch you create to exrude the part).
I have read the manual about doing this several times over. I have double-clicked, right-clicked, highlighted then space bar, clicked on different parts of the dimension, deleted them, recreated, and have done this for almost an hour. I cannot figgure out the special click necessary to allow me to type the value of the dimension.
Thanks again for the basic help.
Joe Dunfee
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
