Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X
Hi,
I have created one pipe by taking follow pipe of two pipes and joined it by connect command. but i dont want whole pipe, want to remove unwanted pipe length.
So is there any method to remove unrequired pipe.
In this snap, i have created pipe by taking reference of another two pipes (follow pipe), and brake pipe at one location and want to remove that portion. But pipe segment is remaining there. not able to remove complete pipe length after break point.
So is there any other way to achieve this?
-Prashant pandarkar