How to report the sheet metal K-Factor in a parameter for a note.

[mdebower]

Hello All:

I am trying to report the sheet metal K-Factor in a note, and am running into a roadblock. There is a sheet metal parameter, smt_k_factor but I cannot get it to display.

Anybody successfully done this? If so, how?

-marc

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[ptc-218373]

Marc - I don't know of a way to display the K factor parameter value,
but you need to beware that if you're using a Bend Allow table, the K
and Y values are ignored (controlled in the table) and their listed
values do not update correctly. We found it worked to have a drawing
table that listed the 3 bend tables with their corresponding K and Y
values, with a cell where you could tick off the appropriate one used
in the model. Not very parametric however.

Dave Tate

Quoting Marc DeBower <->:

> Hello All:
> I am trying to report the sheet metal K-Factor in a note, and am
> running into a roadblock. There is a sheet metal parameter,
> smt_k_factor but I cannot get it to display.
> Anybody successfully done this? If so, how?
> -marc
>
>