cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Insert/Import Parameters to Existing Assembly

a_valle1
4-Participant

Insert/Import Parameters to Existing Assembly

I wanted to know if there is anyway to import paramaters from an already existing assembly file to another. I know there is a way to import using a .xml but I don't have an xml file. What I mean is I have an existing blank .asm file with parameters already set up and I want those to be imported into an existing asm I already have which contains no paramters but the built in ones. I really don't want to have to restart this asm as it was very time consuming. Any suggestions would be appreciated. 

4 REPLIES 4
tbraxton
22-Sapphire I
(To:a_valle1)

Open the blank.asm and export the parameters as an .xml file. Import this .xml into the .asm file where they are needed.

========================================
Involute Development, LLC
Consulting Engineers
Specialists in Creo Parametric

I'm working with Creo 4.0 here, and I found that you can open the parameters dialog, select all the ones you want to copy, then right-mouse-button Copy. Open the assembly/part you want to copy them to, open its parameters dialog, then right-mouse-button Paste. It will complain if any of the parameters are already in the target, but that's a good thing.

BenLoosli
23-Emerald II
(To:a_valle1)

They can be imported by using a mapkey.

Check out the attached file and modify for your own parameters.

 

Chris3
21-Topaz I
(To:a_valle1)

In addition to the other comments, if this is a systemic problem and not just a one-off you can look into implementing Model Check which can create and check the parameters for you.

Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags