Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Translate the entire conversation x

Is it possible to create a flat pattern of a helical part in a sheet metal module of Creo Parametric?

Vladimir_G
12-Amethyst

Is it possible to create a flat pattern of a helical part in a sheet metal module of Creo Parametric?

Hello, everyone!

Is it possible to create a flat pattern of a helical part in a sheet metal module of Creo Parametric?

Thank you in advance.

Best regards, Vladimir.

helicalsweep.jpg


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
ACCEPTED SOLUTION

Accepted Solutions
KrisR
12-Amethyst
(To:Vladimir_G)

Have you tried converting this part to sheetmetal, then creating a flat pattern to see?

If you don't want to do it on the original, save a copy as a different name, then attempt it.

View solution in original post

4 REPLIES 4
KrisR
12-Amethyst
(To:Vladimir_G)

Have you tried converting this part to sheetmetal, then creating a flat pattern to see?

If you don't want to do it on the original, save a copy as a different name, then attempt it.

Hi Vladimir...

This is definitely possible. There's a thread on here from about 4 months back where we did something very similar. I'll look for the thread and see if I can post a link.

Thanks!

-Brian

Hello, Kris, Brian.

Thank you very much for your help!

At last I managed to do it.

Kris, you were right. I made a small change in the model so to get a linear edge in it, then I converted this model from a solid part to a sheet metal part (that is an interesting fact, because I initially made this part in a sheet metal module). When I were creating a flat pattern I chose this linear edge to fix it. The result is perfect. That is exactly what I want.

Kind regards, Vladimir.

answer.jpg

answer2.jpg

KrisR
12-Amethyst
(To:Vladimir_G)

So glad I could help, Vladimir!

But keep in mind....you CANNOT convert back to a standard part.

Once you go sheetmetal, going back is unsuccessful!

Announcements
NEW Creo+ Topics: Real-time Collaboration

Top Tags