Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Hello all,
I would like to create a mapped mesh on the red areas (see figures) but a window appears "Mesh Region is not valid as its face overlaps with another mesh region face".
I found this document Mapped Mesh of a Cylinder.pdf - Google Drive which explains the method but it doesn't work for my simulation.
Somebody helps me to understand why it doesn't work?!
Thank you for your answer !
Unfortunately, I forget to mention one detail: there is an angle (95°)