cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Stay updated on what is happening on the PTC Community by subscribing to PTC Community Announcements. X

Mirror problems in Creo1 parametric

TonyRoberts
7-Bedrock

Mirror problems in Creo1 parametric

I have created a solid feature by merging quilts. When I try to mirror the feature, I get a "reference is not in geometry" failure - even though this reference was used to make the solid part. What causes this type of failure and how is it fixed? Thanks.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
ACCEPTED SOLUTION

Accepted Solutions

6 REPLIES 6

upload your prt。

File is attached. Thanks in advance

1.jpg2.jpg3.jpg4.jpgBy creo 2.0

Got it! Thanks so much for your help.

I see one solidify in your model just before the one you're attempting. That's a clue. I'll take a look at this and get back to you.

What type of mirror are you using? Are you doing anything special?

Kevin
12-Amethyst
(To:TonyRoberts)

I could be wrong here but if you are just trying to mirror the solidify feature you are going to have problems since it depends on the surface geometry which needs to be mirrored for the feature to be created or you can try selecting PRT0003.PRT in the model tree and mirror.

Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags