Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Hi everyone.
I recently bought creo Tool design extension. I am not able to get parting lines properly on step files.
I tried solidifying these files as well but could not work.
Please find the attached files for your reference.
Kindly do the needful.
I messed with the simpler one a little, I think you do want to tweak the part a bit to get it better.
Hi Matt Gris world,
Could you please guide me to get those curves.
The components which I have got are all of similar kinds.
Request you to please send an screen shot procedure for the same.
Thanks and Regards,
Sanket
The part still needs some work. this alone is not going to do it.
