cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Offset lines in exploded view drawing

dbreen
Newbie

Offset lines in exploded view drawing

Hi everybody,

 

I'm making an exploded drawing view which contains several offset lines. I've no problem creating the view in exploded state including the offset lines, however the offset lines are not only shown between the parts but are also overlap the parts as shown in the attached image. Does anybody know what to change in order have no overlap?

 

Thanks in advance!

 

Dave

 

offset lines.JPG


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
2 REPLIES 2

Re: Offset lines in exploded view drawing

Here is one idea to vote one. Not sure if this is exactly what you are looking for:

Smart Explode line - Assembly mode

Here is another:

explode state line - same display in shadind mode

Thanks, Dale

Re: Offset lines in exploded view drawing

Thanks Dale!

The last idea, explode state line - same display in shading mode, describes the problem i'm encountering. Unfortunately there isn't a proper solution than to work around the problem as i understand from the posts.

Thanks for your response!

Dave

Announcements