Hello,
Do we have a PTC recommended standard or a best practice to show up datum planes in drawing?
It is always better to show the datum planes existing in the model or the assembly into the drawing rather than inserting datum symbols or over-riding existing dimensions and show the same as a datum----- This is my view point.
Best regards,
Simha
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
