Parameters in the post

[Mickyd1]

Hello

on one of our machines I need to alter the post so it generates different parameters in peck drilling cycle83 , I don't know where to look to add some parameters for this. Any ideas pls.im using creo 2

thanks mick

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[ptc-2983633]

ex: drill c45 with drill D10(china)

cut_feed: 50-120 mm/p

peck_depth : 1-3 (breakchip)

clear_dist: 1-5

spindle; 500-700 (v/p)

nc post example:G83 X20. Y75. Z-39. Q2. R1. F50.

well done

[ptc-4392950]

Do you mean a parameter in the NC code that can be changed at run-time on the Machine? any luck with that by now?