Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily. X
Morning All
Creo will not allow me to pattern the impeller blade of the attached. I see a few historical posts of something similar, any tips or advice?
Solved! Go to Solution.
Hi,
see my solution ... I am not sure if it is the right one.
MH
Hi,
see my solution ... I am not sure if it is the right one.
MH
Hi Martin
One too many vanes but correct!
Thank You.
Don't forget to mark Martin answer as correct for those who come across this thread to learn about patterning.
Thanks Dale - great tip!
Thank you Phil Szarko for taking action.
Thank you Martin Hanak for the solution.
Best,
Toby