Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Been a few release since I used Creo last.
I don't remember having to hold control when picking entities for dimensions. You could, but it wasn't mandatory.
Am I mistaken?
Sometime back, maybe Pro/e Wildfire 5, they added the "extra" ctrl key. It was supposed to make it consistent with "windows" type programs.
We are just now going to Creo 4... and this is new.
It wasn't required in Creo 2.0
I wonder if there is a setting I can change to put it back the old way...
I wonder if there is a setting I can change to put it back the old way...
Nope.
Well... that's to the point!
Thanks
I had more I was going to say about PTC and their development choices, but I decided it would be better not to.