Placing a UDMF with a family table in an existing Manufacturing model
‎May 04, 2012
02:44 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎May 04, 2012
02:44 PM
Placing a UDMF with a family table in an existing Manufacturing model
I am having an issue placing a UDMF in an existing manufacturing model. When I place the UDMF i am selecting a certain instance from the family tablethat does not place some sequences in the model. The issue is, I have the relations in the program and all of the relations are copied over to the current models relations. If the sequence is not placed in the model the feature ID number is not re-sequenced and interferes with a current sequence that is using the same feature ID number. Is there a solution for this?
Thanks,
Rich
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
- Labels:
-
General
2 REPLIES 2
‎May 04, 2012
02:45 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎May 04, 2012
02:45 PM
I spotted this bug in WF5.0 M90 and it was fixed in M100 as far as I know...
‎May 04, 2012
02:55 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎May 04, 2012
02:55 PM