Prefix and basic dimensions
Jul 18, 2013
05:01 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Jul 18, 2013
05:01 PM
Prefix and basic dimensions
The prefix (such as 12X) is now outside the box. I am revising some "older" drawings and ran into this and found out it is an ENHANCEMENT since WF4. I think as of ASME Y14.5-2009 it should be inside. Is there a setting that will make it behave correctly? I know I could force it by @[12X @D@], but that is a pain!
I'm using WF5
Thanks in advance!
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
- Labels:
-
2D Drawing
1 REPLY 1
Jul 18, 2013
10:10 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Jul 18, 2013
10:10 PM
There are several occasions that we have to go old-school with dimension display. The "upgrade" was to click a button to get the box to show up... but the limitation is that it no longer acts the same. Had similar problems with the diameter symbol in some instances.
