I used Pro/Piping to create the attached. What I would like to do now
is to create shrink tubing that follows the contour of the pipe, but the
length
of the shrink-tubing will be different. (I guess I create another pipe.
I'm just looking for an easier way).
Any helpful suggestions?
WF2
Thank you!
-Art
.
.
.
.
This message (including any attachments) contains
confidential and/or proprietary information intended
only for the addressee. Any unauthorized disclosure,
copying, distribution or reliance on the contents of this
information is strictly prohibited and may constitute a violation
of law. If you are not the intended recipient, please notify the
sender immediately by responding to this e-mail, and delete the
message from your system. If you have any questions about this
e-mail please notify the sender immediately.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
