The community will undergo maintenance on October 16th at 10:00 PM PDT and will be unavailable for up to one hour.
Hi folks,
I've been hiding out on the Planet PTC Communities page for quite some time. I figured it's been too long since I've posted a dumb question here, so here goes...
One of our businesses is upgrading from WF2 to WF5. We tried to open an old assembly process in WF5, but it won't do it. If we open the parent assembly in session, or if we save the parent to workspace/common space, it will open fine. Has anybody else seen this? Does anybody else use Pro/Process anymore?
Thanks,
Jsoh
Joshua Houser| Pelco by Schneider Electric |Buildings & Business| United States| Methods & Tools Sr. Engineer
Phone: +559-292-1981 ext. 3490| Toll Free: +800-289-9100 ext. 3490
Josh,
The good news.....Pro/Process is alive and well in WF5. It still works like that of old versions of Mr. Pro/E.
The bad news....not sure why it's not working.If it'snot opening at all then I suspect you have a different issue other than Process. Can you open reps on their own without the Process module activated? Are you trying to open the process sheets first? I would dig into the reps and process states configurations first and see if you have lost anything there.