It appears you can only open ProDesktop files from a 32bit version of ProE.
I was able to open a .des file (Needed to replace the spaces with underscores for the resulting .prt to work)
I'm not able to open a .dra file. I assume that's a drawing file.
Is it possible to open a ProDesktop drawing in ProE?
David Haigh
Phone: 925-424-3931
Fax: 925-423-7496
Lawrence Livermore National Lab
7000 East Ave, L-362
Livermore, CA 94550
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
