Problem with Repeat Region

[jvadalia-2]

Hi,

Can anyone guide to the options available in Repeat Region?

I want BOM where all the PARTS should be in BOM and not a single Assembly.

Also want all components of the sub-assemblies of top-level assembly.

I know the option of "recursive" and "filter"

But i want that Table.tbl file to be saved for future uses.

Right now when i am saving the table file after applying all settings like recursive and filter by rule "&asm.mbr.type==PART*

Next time when i use that table file. It only shows the PARTS of Top level assembly. And all sub-assemblies along with it parts get filtered out.

So every time i have to work with BOM for the same.

And everytime to identify the PART/ASSEMBLY i have to again add 1 column of &asm.mbr.type (Unwanted) and then i start to set default all settings to BOM and again have to apply the settings.

Can anybody help here?

[MartinHanak · Accepted solution]

Hi,

I can't see any problem ... see attached files created in CR2 M070.

1. I created new drawing
2. I set asm0001.asm as drawing model
3. I imported table from table_2019-02-21.tbl
4. table contains recursive BOM, indentation is set to 0, filter enables PARTs only

[jvadalia-2]

Hey Martin,
In this table bulk items are not populated.

Please help
Jignesh.

[jvadalia-2]

Hi Martin,

Bulk items are not populated in this table.

Please help
Jignesh.

[MartinHanak]

Hi,

bulk items are not displayed because of filter defined in the table ... see below

&rpt.level  > 1
&asm.mbr.type  == PART

You have to investigate, how to display bulk items ... please do it by yourself 🙂