I need help! I'm building a chassi using AFX and, as you can see, it's simetrical. I tried a miter joint in one side (it worked fine), but in the other side it produced a bad joint (the pipes aren't touching each other properly). Image below:
The same problem occured when i tried to use the tool profile cutout. The two pipes are simetrical, but only the left one was cutted correctly (i mean: i could made the cutout with the two pipes below it). In the right pipe i was able to made a cutout with just one of the two pipes below it (when i tried the cutout with the other pipe, a error pop up appeared but with no information about where the problem is). Image below:
Does anyone knows why does it happen? What's the solution? I intend to use this chassi to make simulations in creo simulate.
Thanks for the attention.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
