Round Problems!!!

[carlofernando]

Good day all Creo2.0 Users!!!

We would like to to ask if you encounter problems regarding rounds in creo, because

in our case simple round commands take too much time before it applies to our model.

Is there any technical reason why this command feature takes too long before it execute?

Please help us !!!

Thank you in advance!

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[SamuelBrantner]

that depends on your model i'd say. Do you have an example?

[TomD.inPDX]

If you are referring to Auto Round, it has to find all the edges and apply rounds to each one. It is really cumbersome in regenerations as well. It is a nice feature, but you might consider using it at a later stage of the design.

General rounds are quite responsive from what I can tell. They can get somewhat bogged down it the geometry is less that simple linear forms.