Question
SECTIONAL DIMENSION VIEWS
I am having a senior moment. I have driven a sweep along a path and I
want to put the dimensions on a section that is not the sectional plane
for the sweep section. I can show them but then of course the leaders do
not align. Other than scrapping what I've done, I'm sure that there is a
way to do this, can anyone help out?
Thanks
Richard A. Black
Lead Design Engineer
Eaton Corporation
440 Murray Hill Road
Southern Pines
NC 28387 USA
tel: 910 695 2905
fax: 910 695 2901
-
www.eaton.com
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
want to put the dimensions on a section that is not the sectional plane
for the sweep section. I can show them but then of course the leaders do
not align. Other than scrapping what I've done, I'm sure that there is a
way to do this, can anyone help out?
Thanks
Richard A. Black
Lead Design Engineer
Eaton Corporation
440 Murray Hill Road
Southern Pines
NC 28387 USA
tel: 910 695 2905
fax: 910 695 2901
-
www.eaton.com
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.