Set Datum Display/Attachment (solution)

[mwimberly]

This is the solution that I have used to get what I wanted. It is a good work around because it is basically what we are doing by putting them "in" the dimension.


THE gtol is placed as a free note and then Edit > grouped to the dimension
the datum can then be placed in the GTOL

[cid:image009.jpg@01CCF233.DFFEE6A0] [cid:image010.jpg@01CCF233.DFFEE6A0]


Michael Wimberly
System Administrator, Sr
Intelligence & Security

T 513 881-4843 | M 513 833-3565 | F 513 881-5087 | -<">mailto:->
www.baesystems.com

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[joe_c]

Michael

I ran into the same problem placing datum on a dimension. I tried gtol_datums to std_asme and flipping witness line and nothing changes. The triangle is behind the box fromwhat i see. please let me know what else