Creo 2, M120In the past I've put a simple 3D note in my part & assy models, attached to an edge somewhere, to show some information like the internal volume. I put them on a layer so I can turn them on or off.In Creo, complex annotation features have taken over and creating a simple note with a leader is evading my grasp. How do I do this?--This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
--
Doug Schaefer | Experienced Mechanical Design Engineer
LinkedIn