Simulate Reality

[DenisJaunin]

Hello,

Do you know where it would be possible to retrieve the file from the example of the staple that folds into reality Simulate, page 4, in the attached document.

Cordially.

Denis

http://www.3hti.com/wp-content/uploads/documents/Top-10-Reasons-to-Upgrade-to-Creo-Parametric.pdf

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[DenisJaunin]

Hello,

I added a better picture of the folding of the clip.

If the file was available, it would be interesting to adapt the application.

Cordially.

Denis

[SylvainA.]

Bonjour,

je ne vais pas vous êtres d'une grande aide, mais le plus simple serait peut-être de reconstruire l'assemblage en vous basant sur les images disponibles. (The easiest way could be to design an assembly by yourself, based on these pictures)

Cela vous permettrait de plus de tester les différentes fonctionnalités de Pro/Mechanica(Simulate). (This will allow you to try Pro/Mechanica possibilities)