Playing around a bit with hyperlinks on drawings.
Read about hyperlinks on formats and that they need to be inside a table note.
Prepared a format and created a new drawing with that
In the examble below there is a drawing table that originated from the format and shows the modelname through report parameters (2999570-01)
Hoping
for a hyperlink containing the 2999570-01 code I only got the section that's not mark yellow
Is there a way to have the hyperlink constructed from fixed portion + table cell content
The above was ssetup on WF4
Has creo taken it further ?
The purpose of this all would be that I can go from my drawing/pdf directly to my PLM system
