The community will undergo maintenance on October 16th at 10:00 PM PDT and will be unavailable for up to one hour.
I would like to run a report in Creo Schematics that will sort all of my wire numbers in numerical order. Our wire numbers are not prefixed with 0's, so if I have 10 wires and I sort by wire number it comes out as follows:
1
10
2
3
4
5
6
7
8
9
How can I get the 10 to come after 9?
Thanks!
I have asked PTC tech support about this for years and they say it is the intended functionality so there is no way to do it. Really? I think this problem was solved back in the 70's with DOS. Trying to figure it out in a JAVA API or something.
Hi,
This issue was resolved in Creo Schematics 3.0.
Gaby
good
try this!!
001
002
003
etc....