Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Are there T-slot nut inserts available for ITEM profiles?
@JB_87049 wrote:
Are there T-slot nut inserts available for ITEM profiles?
Hi,
I hope @SamuelBrantner can answer your question.
Thank you for your response.
It was a question by one of my students (I'm a lecturer at the KU Leuven (Catholic University of Leuven) in Belgium).
I've now suggested a work-around for my student and made a video about it
https://www.youtube.com/watch?v=E22BUUmdXiE&t=228s
Any suggestions are still very welcome.
I hope everyone here stays safe and sound during this Corona crisis.
John
Nice. You could make this even easier to insert by designing an interface for the T-slot nut, which will save a lot of time when placing your constraints.
Hi @JB_87049,
we currently only offer those for the Bosch system.
If you only use the elements for educational purposes then maybe you can switch to Bosch?
It would of course be possible to create the elements for Item as well.
Greetings Sam