Question
Tolerance display with a named dimension?
Hi all,
I'm having a small issue with a named dimension. I'm using the "@S" convention to show the name of the dimension instead of the numerical value, and Pro/E won't let me also display the dimension tolerance. Is there a magical trick to do this?
I'm on Creo 1.0, M020
Thanks,
Tim
Tim Giauque
Project Engineer II
FN Manufacturing, LLC
Phone (803) 736-0522 x383
Fax (803) 865-3543
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
I'm having a small issue with a named dimension. I'm using the "@S" convention to show the name of the dimension instead of the numerical value, and Pro/E won't let me also display the dimension tolerance. Is there a magical trick to do this?
I'm on Creo 1.0, M020
Thanks,
Tim
Tim Giauque
Project Engineer II
FN Manufacturing, LLC
Phone (803) 736-0522 x383
Fax (803) 865-3543
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.