cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Tolerances in hole tables

ccire
1-Newbie

Tolerances in hole tables

Hi,

 

I have a part with many holes, some with plus-minus tolerances, others with H7 tolerances.

I can't find a way to show these tolerances in the hole table.

 

Anybody knows how to do this ?

 

Thank you !

 

Eric


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 ACCEPTED SOLUTION

Accepted Solutions

Hi Eric,

From the following document, this does not seem to be a functionality though it does suggest a workaround.

https://support.ptc.com/appserver/cs/view/solution.jsp?n=CS158230

View solution in original post

2 REPLIES 2

Hi Eric,

From the following document, this does not seem to be a functionality though it does suggest a workaround.

https://support.ptc.com/appserver/cs/view/solution.jsp?n=CS158230

The workarounds in that document are extremely poor. Workaround 1 is non associative and so I would not consider using. The second workaround is only good for feature parameters and not model parameters and so I can't see how that is any better.

Thinking about this further, this Product Idea has in effect been closed as Answered which it has not. You have mentioned workarounds which as far as I am concerned are not feasible workarounds. I would like to see this put forward as a Product Enhancement.

Top Tags