cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

Two parameters in drawing template are not appearing once we upgraded from creo 7.0.8.0 to 9.0.7.0

MR_11123310
5-Regular Member

Two parameters in drawing template are not appearing once we upgraded from creo 7.0.8.0 to 9.0.7.0

We have two parameters 'DRW_RELEASED_ON' & 'DRW_RELEASED_BY' in our drawing template. Source for these parameters is Windchill. Meaning, the values for these parameters will appear automatically when the drawing is released. All this worked fine in Creo 7

 

When we upgraded to Creo 9, I could not see these two parameters in the drawing template. Becuase of this, values for these parameters are not getting populated after the drawing is released.

 

Can someone help? where exactly this issue is there?

3 REPLIES 3

Hi @MR_11123310

Thank you for your question!

Your post appears well documented but has not yet received any response. I am replying to raise awareness. Hopefully, another community member will be able to help.

Also, feel free to add any additional information you think might be relevant. It sometimes helps to have screenshots to better understand what you are trying to do.

 

Best regards,

Catalina
PTC Community Moderator
Dale_Rosema
23-Emerald III
(To:MR_11123310)

MR_11123310
5-Regular Member
(To:Dale_Rosema)

I posted this question also 😋

Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags