cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - You can Bookmark boards, posts or articles that you'd like to access again easily! X

UDF Annotation and MBD

JBB
10-Marble
10-Marble

UDF Annotation and MBD

I've been tasked to determine if it is possible to annotate (modify) our present UDFs to include annotations that will show up in an MBD model. 

Currently we can place the UDF, a counterbore hole, for example, on the model . However, then we must dimension the UDF manually in the combination state. Is there a way to attach the callout to a UDF so it becomes integral with the combination state?

I suppose this would be applicable to a non-MBD part also. Can the callout be attached to the UDF when the UDF is placed on a part?

Our UDFs are all Stand Alone also and we use Creo 9.3.

 

JBB_1-1723651041696.png

 

Thanks for any guidance!

ACCEPTED SOLUTION

Accepted Solutions
Mfridman
16-Pearl
(To:JBB)

Hi @JBB 

You can include annotations as part of your UDF definition and have them to show up when you instantiate the UDF to a another part.

In order to do so you need to make sure that the annotations in the UDF are created as Annotation feature owned annotations.

 

Best Regards,

Michael

View solution in original post

2 REPLIES 2
Mfridman
16-Pearl
(To:JBB)

Hi @JBB 

You can include annotations as part of your UDF definition and have them to show up when you instantiate the UDF to a another part.

In order to do so you need to make sure that the annotations in the UDF are created as Annotation feature owned annotations.

 

Best Regards,

Michael

JBB
10-Marble
10-Marble
(To:Mfridman)

Michael,

Thank you for responding.

Regards,

Jon

Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags